-
Email
-
WhatsApp
-
Address
Zhengzhou,Henan,China
Zhengzhou,Henan,China
Aluminum Tread Plate. Raised four-way Diamond Pattern – has an approximate 1″ center – opposite side is smooth. Excellent for locations requiring metal, skid resistant floors. The non-sparking characteristic adds a measure of safety where combustibles are present. *Thickness is measured exclusive of projections.
For precipitation hardening, the metal should be placed in 320 degrees F for 18 hours, air cooled, then placed in 350 degree F for eight hours, and then air cooled again. The 6061 T6 aluminum tread plate is available in sizes between .125 and .375 inch thick, 48 inches wide and up to 192 inches long. Thickness. Min: 0.125.
Length: Max: 1925 bar aluminum tread plate 5052 H32, size: 1200 × 6000 × 4 mm. Aluminum checker sheet with thickness 1.1 mm and size 1220 mm × 2440 mm. Aluminum perforated sheet with thickness 1 mm and size width 1250 mm × length 2500 mm. Hole size: 0.188", space between centers: 0.43". Embossed aluminum sheet with sheet size 1220 mm × 2440 mm (4' × 8 ...
Aluminium 5 Bar Tread Plate: A very common mistake made when ordering Aluminium Tread Plates is over the thickness of the product, O/P means On Plane not over pattern, as an example 4.5mm O/P Tread Plate will give you an over all thickness of approximately 6mm including the pattern. 2500 x 1250 x 2mm O/P Aluminium 5 Bar Tread Plate.
Material: Aluminum steel sheet with mill or polish finish. Width (mm): 600, 1000, 1200, 1500, 1800 mm. Length (mm): 1200, 1500, 2000, 3000, up to 6000 mm. Pattern: diamond pattern, willow leaf (2 bars and 5 bars), lentils pattern. The price of aluminum checkered sheet depends on the required volume of purchase, thickness, and sheet size.
Perforated Aluminum Sheet is a sheet product that has been punched with a wide variety of hole sizes and patterns providing an aesthetic appeal.Perforated Aluminum Sheet offers savings in weight, passage of light, liquid, sound and air, while providing a decorative or ornamental effect.
ISO2107 Aluminum, Magnesium and their Alloys-Temper Designation ISO6361-2 Wrought Aluminum and Aluminum Alloys, Sheets, Strips, and Plates 2.4 ANSI Standards:5 H35.1/H35.1(M) Alloy andTemper Designation Systems for Aluminum H35.2M Dimensional Tolerances for Aluminum Mill Prod-ucts 2.5 AMS Specification:6 AMS 2772 Heat Treatment
T361 andT861 were formerly designatedT36 andT86, respectively. (g) Based on 107 cycles using flexural type testing of sheet specimens. (h) Based on 1⁄ 4 in. thick specimen. (i) T7451, although not previously registered, has appeared in literature and in some specifications as T73651. Understanding the Aluminum Temper Designation System / 41
